
	Home

	Services

	Electronic solutions

	Ongoing projects

	Injectors High impedance injectors Low impedance injectors Injector accessories

	Pumps Fuel pumps Water pumps

	Fuel pressure regulators

	Accessories Engine Turbo Check valves Seals O-rings TEFLON intake seals Specific seals Connectors for liquids Electrical connectors Bodywork Other parts

	Special 405 T16 and transmission x 4 Engine accessories Hoses Engine/transmission management parts Clutch Clutch control Exhaust Parts box transfer T16 and x 4 Other parts of transmission T16 and x 4 Kits turbo GT 2860RS Kits turbo GT 2871R GTX 2867R Gen 2 turbo kits Injection parts kits ECU reprogramming for modified cars ECU reprogramming for original cars

	Gearbox ME5

	Clutch

	BRESCH engine management parts

	Terms & Conditions

Injection parts kits

1 2

Injection Kit high performance 450, high octane gasoline SP8

Kit of parts injection performance ready to mount on PEUGEOT 405 T16 or engine XU10J4TE with original injection system, and specific computer programming:

Included:

Pump high flow up to 450 HP in 2 bars of overeating. Installation facilitated by its great compatibility with the original pump: power and input fuel 100% compatible; a banjo connector is provided for fuel output (no modification of the original fuel line). Requires a 60 mm pump body holder.

Four injectors four jets, high impedance, up to 450 HP under 3 bar fuel pressure (regulator of origin). Very quiet, impeccable idle. Fissiparous washers provided to slightly spread the injector of the splitter bar.

Two 3 bar absolute pressure sensors. 100% compatible, mechanically and electrically, with original sensors.

Reprogramming ECU MAGNETI MARELLI 1AP10 XU10J4TE, injectors and pressure sensors supplied in this kit. Turbo control for turbo GARRETT GT2860RS; requires a controller for any other turbo boost.

Calculator improvements:

ignition advance
wealth
turbo pressure
Rev limiter (7200 rpm or more, custom)
permission turbo pressure in 1st
special departures arrested: acceleration of the detection of the 1st report (turbo pressure arrive earlier)
management for vehicles without speed sensor (swaps)

ATTENTION: A reinforcement of the transmission on PEUGEOT 405 T16 is essential to take full advantage of this kit, cad to reduce the risk of mechanical:
Reinforcement of the central differential by change of the axes and the satellite cage
The tripod of longitudinal shaft reinforcement
These parts are available in the transmission (machined) parts.

Power: up to approximately 450 HP according to the turbocharger, a GT2860RS 350 HP depending on motor unblocking.

ECU preparation including:

the amendment of the calculator (installation of support for any later developments)
the installation of the new programming
? the tight closure of the calculator
** the packages recommended and assured return

1 2

Site web créé avec Lauyan TOWeb

Dernière mise à jour : jeudi 5 décembre 2024